agacad.com

Main Frame

Rotated Plates

Filters

  • Stud Filters – lets you create a filter based on parameters to exclude certain studs. Rotated plates will not receive nailing where the filtered studs are.

    Note: Filter should be configured in a way of what you want to keep and not what you want to exclude.

  • Plate Filters – lets you create a filter based on parameters to exclude certain rotated plate elements from being nailed.

    Note: Filter should be configured in a way of what you want to keep and not what you want to exclude.

Rotated Plates Nailing

  • Perform – turns the nailing functionality on and off.

  • Bottom Offset -

  • Top Offset -

  • Layout Direction - lets you choose a nailing layout:

    • Center - nails are aligned with the middle of the plate with fixed nail amount and spacing

    • End - nails are aligned with the top side of the plate

    • Start - nails are aligned with the bottom side of the plate

    • Start End - nails are aligned to both sides of the plate

  • Layout Rule - lets you choose according to which inputs should the nails be placed:

    • Fixed Number & Fixed Spacing – both fixed number and spacing is taken into account.

    • Fixed Spacing/Maximum Spacing – only fixed spacing will be taken into account.

  • Fixed Number - lets you choose a number of nails required.

  • Fixed Spacing/Maximum Spacing - lets you choose spacing between nails.

  • Nailing Type/Device Index - machine-specific code to control and customize various aspects of how the processing is supposed to be performed.

Pads

  • Bottom Pad Element as - lets you choose what processing command code is supposed to be used for bottom pad elements:

    • UG - bottom plate

    • LS - longitudinal stud

  • Top Pad Elements as - lets you choose what processing command code is supposed to be used for top pad elements:

    • OG - top plate

    • LS - longitudinal stud

Pads Nailing

  • Perform – turns the functionality on and off.

  • Start Offset – moves the last nail from the start of the element by a set distance

  • End Offset – moves the last nail from the end of the element by a set distance

  • Side Offset -

  • Nailing Spacing -

  • Incremental Nailing Spacing -

  • Nailing Type/Device Index - machine-specific code to control and customize various aspects of how the processing is supposed to be performed.

Plates

  • Bottom Plate Element as - lets you choose what processing command code is supposed to be used for bottom plate elements:

    • UG - bottom plate

    • LS - longitudinal stud

  • Top Plate Elements as - lets you choose what processing command code is supposed to be used for top plate elements:

    • OG - top plate

    • LS - longitudinal stud

Last updated