Siding Trimming
Here are the options to control how the siding elements are going to be trimmed:
Table
Operation – provides a number for reference to use with the preview image.
Trimming – provides a description of the processing area.
Perform – turns off operation for the specified area.
Control Code – machine-specific code to control and customize various aspects of how the processing is supposed to be performed.
Command Code – lets you choose what processing command code is supposed to be used:
PSG (default) – sawing process.
PAF – countersinking process.
Cut Direction – lets you choose the direction the saw travels on specific cuts.
Note: Only available for horizontal siding elements and left/right sides of the opening
Tilt Angle – lets you choose the tilt of the saw, resulting in angled cuts. 0° results in a square cut.
Blocked Area -
Cut Start Offset – this lets you apply offsets to the start of cut lines to avoid overcutting or undercutting. Use negative values to shorten cut lines, and positive for lengthening.
Cut End Offset – this lets you apply offsets to the end of cut lines to avoid overcut or undercut. Use negative values to shorten cut lines, and positive for lengthening.
Other Options
Merge Blocked Areas -
Last updated
